Tube Screamer genealogy – cidadessustentaveis.info
TS Overdrive Pro: the first Tube Screamer, introduced somewhere around (I don't have an exact date here). There were. Results 1 - 20 Dating ibanez ts9 - Is the number one destination for online dating with more ibanez screamer ts9/ts is a boss or ibanez ts9, have a tube. Can anyone tell me how I can tell what year my TS was made in and where the serial number can be found? The only number I found was.
Ibanez Tube Screamer
If you have a you can change it to to improve switching switching is the one thing about TS-9s that sucks! I think the new TS-9 sounds the same as the earlier reissues and last originals. In late the largest change to the TS9 ever took place. Ibanez is now having another company make them. The new TS9s are now easy to distinguish.
The battery covers had never been changed since the original TS The input jacks on the late models were terrible and tended to jam, with the plug stuck in tight. In they made them a little better. Otherwise they are about the same as the Maxon made TS9 pedals and seem to sound the same. But the boards are more fragile, so extreme care needs to be taken when modifying them. But they should be fine, we have not had many problems with these, and the switches seem better than before.
They did seem to start using them in the USA more recently. On the right is an original with black label, easy to tell and date, if 1st digit is a 1, that would mean a VERY early TS9! Second on the right is an original silver label TS9. The 1st digit is a 3 meaningyou will see a lot of these with a 4 for These can have the earlier chips or sometimes the TA chip as used in the reissues.
These are almost impossible to tell from the 1st reissue TS9. But the Reissue TS9 will usually not have a serial starting with 3 or 4. I have reissues with a XXX and XXX number here with a capacitor made inmaybe a very early reissue from These have silver labels, an original from would probably have had a black label.
I also see a lot of TS9s with serial starting with 1 with a silver label. These are all reissues as a would be a TS or a very early TS9 with a black label. However I have seen a TS9 with serial number with a silver label. It has the JRCD chip and capacitors with date codes and resistors coated in green.
So if the first digit is 2 and the label is silver you will have to open it up to date it. I have also seen a Ts9 chip, caps dated and green resistors with the serial number and a silver label. If it's a silver label, it's hard to figure out if it's original unless the serial number starts with 3 or 4. Yes this is confusing You may find which meansetc.
See below for more on dating the capacitors. Third from the right is a 2nd version reissue, with the CE symbol. All TS9s with the CE are reissues. The reissues all have the TA chip. Note the box has bar code info, this will not be found on the original boxes. Ts9 circuit parts You can tell an early TS9 by the green coated resistors inside.
But I have a TS that has mostly tan coated resistors and a few green ones so they were not consistent.Ibanez TS808 Tube Screamer Overdrive Replica - Preview
Some late originals used the brown coated resistors also, so check the date codes on the electrolytic can capacitors. Usually the first two digits are the year, as in the pictures below: Also you can tell the original JRC chips as they are shiny and dark, while the new chips are dull and a bit grey looking. Reissue TS9 board below: It looks fine except the color seems a bit off.
See my tube screamer page for more info. Each position adds low end, increases volume, and actually decreases distortion. The 1st mode is the same as a TS9, the 2nd is not too bad but the 3rd and 4th are too much.
It is made in Taiwan like the TS5 but in a metal case that should stand up better.
Analog Man Vintage guitar effects
There are several circuit boards inside, they seem to be generic and several different effects can be built using the same boards they are mostly empty boards! These have a HOT mode switch for extra distortion and volume, which is quite useable. The HOT mode still works after the mod, and gets a similar improvement to the tone less harsh, smoother, but still has lots of drive.
All the boards, connectors, and cables inside add a lot of complexity and there are many things to break. Also the tiny micro switches seem to be failing and we do not carry replacements.
It does not use a circuit board, instead parts are hand soldered onto a strip board like some old fuzz pedals, our Beano Boost, and many prototypes. The parts are about the same as a normal TS except I noticed they used our King Of Tone clipping diodes, which makes them a little louder and less compressed.
They also have true bypass and come in a cool box. Current production units TS-7 Tubescreamer: It also has a gain boost switch, which more than doubles the max gain.
Current production models are much more reliable, though. All in all, the TS7 — as indeed the whole 7 series — is a good, if slightly underrated pedal.
TS-9 Tube Screamer reissue: The switch the little tactile switch inside is different, though, so if you take it out the difference is clear.
TS Tube Screamer reissue: This is — save for the value of two resistors and the type of adapter jack — the exact same thing as the reissue TS-9, but in the older style box. This is a good-sounding TS, no doubt.
Ibanez Tube Screamer History
And I could use the normal adapter plug… The TS does come in a cooler box, though, and one that allows you to fit a true bypass switch a bit more neatly — rather than drill a hole through the nameplate as you would do on a TS-9the switch can be mounted where the stock switch is. A handwired version of the Released inthis is a TS with three added modes. The very first batch back in had an error in the circuit board that holds the gain pot, preventing it from reaching full gain.
The TS9 mode sounds exactly like the TS-9, while the other three modes offer increasingly dramatic boosts in bass response and volume, with equal dramatic reductions in the amount of distortion. I doubt one will make it to my bench, though, since the subminiature components that allow the pedal to be shrunk down to this size does make it quite hard to modify. A Tube Screamer with a boost section that can be placed before or after the overdrive circuit before if you want more distortion, after if you want to boost the volume.
Which one to get? Finding a TS at a reasonable price is nearly impossible. For a darker, deeper sound, the TS5 is really good — but you do need to take care when using it, as it is more fragile than the others.
Some of them are fairly full-on circuit copies, while others are more distant cousins. Some clearly signal their heritage, while others are less obvious.